Introduction: The PTL-MM01 pull-film applicator grows the film by vertically pulling the sample in the liquid phase. This machine is controlled by a single board machine, which is stable and accurate. It is an ideal equipment for universities and research institutes. PTL-MM01 pull coating machine can be equipped with up to 200 °C incubator, providing a stable temperature environment for lifting coating. Products have passed CE certification. Technical Parameters: 1, power supply: 220V 2, power: 50W 3, pull speed: 1mm/min-200mm/min 4, speed stability: ± 0.05% 5, sample size: 75mm × 25mm × 2.5mm Product size: 320mm × 260mm × 560mm; Product weight: 18kg Installation conditions: This equipment is required to be used at altitudes below 1000m, temperature 25°C±15°C, and humidity 55%Rh±10%Rh. 1, water: no 2, electricity: AC220V 50Hz, must have a good ground 3, gas: no need. 4、Workbench: size 800mm×600mm×700mm, load-bearing more than 200kg 5, ventilation device: no Standard accessories Anti-swing control seat: 1 set Sample fixture: 1 set Loading cup: 1 Tirlas: 3 Optional accessories 1, rapid sample fixture 2, Tiras
Introduction: The PTL-MM01 pull-film applicator grows the film by vertically pulling the sample in the liquid phase. This machine is controlled by a single board machine, which is stable and accurate. It is an ideal equipment for universities and research institutes. PTL-MM01 pull coating machine can be equipped with up to 200 °C incubator, providing a stable temperature environment for lifting coating. Products have passed CE certification.
