Introduction: The MSK-AFA-EC200 scraper coating machine is a new automation device specially developed for the surface coating of foils, which is newly developed by the Krystal Group. It can realize a very uniform thin coating on the surface of the substrate and it is baked. Dry system automatically drying. This machine can be continuously and continuously coated, suitable for battery research and development experiments and sample production, and has a certain degree of versatility, and is widely used in film, paper and composite materials industries, and has a high production efficiency. Features: 1. It has an automatic stirring rod to make the slurry more uniform when coating. 2, automatic tape, automatic winding, and equipped with a pole piece positioning block, to ensure that the tape winding neat and consistent. 3, with a drying system, automatic drying coating. 4, coating tension is adjustable, continuous intermittent coating, high coating accuracy. Technical Parameters: Input power: AC220V 50Hz Maximum power: about 3KW Substrate width: up to 200mm Coating width: 180mm Coating speed: 200mm/min (adjustable) Coating thickness: 20μm-200μm (based on coating material drying) Coating accuracy: ±6μm (edge error ±8μm) Tension control: automatic adjustment of retractable roll Retractable coil diameter: maximum Φ200mm Closing and unwinding mandrel: 3 inch, T-screw/gas lift shaft Correction accuracy: ±0.5mm Drying temperature: maximum 150 °C ± 5 °C Oven length: 500mm Drying method: resistance wire heating, blowing up and down Size: 1000mm×650mm×650mm Installation conditions: This equipment is required to be used at altitudes below 1000m, temperature 25°C±15°C, and humidity 55%Rh±10%Rh. 1, water: no 2, electricity: AC220V 50Hz, must have a good ground 3, gas: need to prepare its own air source or air compressor 4、Workbench: size 800mm×600mm×700mm, load-bearing more than 200kg 5, ventilation device: need
Introduction: The MSK-AFA-EC200 scraper coating machine is a new automation device specially developed for the surface coating of foils, which is newly developed by the Krystal Group. It can realize a very uniform thin coating on the surface of the substrate and it is baked. Dry system automatically drying. This machine can be continuously and continuously coated, suitable for battery research and development experiments and sample production, and has a certain degree of versatility, and is widely used in film, paper and composite materials industries, and has a high production efficiency.
