ZR-D09QT smoke and dust multi parameter direct reading sampling tube Brief introduction: ZR-D09QT smoke and dust multi parameter direct reading sampling tube β The principle of ray absorption weighing is used to cooperate with the smoke and dust host to automatically sample and accurately measure the particle concentration in the organized exhaust gas from the fixed pollution source. It is small in size, high in measurement accuracy, and easy to carry and install. With an independent flue gas sampling pipeline, it can measure the dynamic pressure, static pressure, temperature, flow rate, benchmark flow, etc. of the flue. It is widely used in environmental protection, testing companies, industrial and mining enterprises (power plants, iron and steel plants, cement plants, sugar plants, paper mills, smelters, ceramics plants, boiler kilns, as well as aluminum, magnesium, zinc, titanium, silicon, pharmaceutical industries, including fertilizer, chemical, rubber, material plants, etc.), health, labor, safety supervision, military, scientific research, education and other fields. characteristic: 1. Adoption β The sampling method combined with X-ray and filter paper tape can not only realize on-site concentration direct reading, but also realize short-term online monitoring, which is applicable to environmental protection law enforcement, rapid detection, and online instrument comparison; 2. Real time measurement of moisture content; 3. The flue gas pretreatment function is added, which can cooperate with the electrochemical sensor of the flue dust host or the ultraviolet cold dry method of ultraviolet flue dust for the simultaneous extraction of dust and gas, and the oxygen content can be measured at the same time of dust extraction; 4. It can measure the angle in horizontal and vertical directions in real time, and has tilt alarm function; 5. It has a color touch screen, which is easy to operate and display the instrument status parameters in real time; 6. The front and rear paper feeding mechanisms operate stably and reliably to ensure the measurement accuracy; 7. The wall of sampling tube is treated with inert process to reduce the absorption of smoke particles; 8. Pitot tube can be disassembled for easy maintenance; 9. It has Bluetooth communication function with smoke host (optional); 9. Fault alarm function; 10. The filter cartridge sampling nozzle can be selected. When the concentration is greater than 50mg/m3, the filter cartridge can be replaced for sampling. Technical parameters: Sampling flow: (0 ～ 50) L/min Calibration method: standard membrane calibration Working power supply: DC24V 10A Overall dimension: (340 long × 135 wide × Height 270) mm Length of sampling tube: standard 1.5m, customizable Power consumption: ＜ 240W
Brief introduction: ZR-D09QT smoke and dust multi parameter direct reading sampling tube β The principle of ray absorption weighing is used to cooperate with the smoke and dust host to automatically sample and accurately measure the particle concentration in the organized exhaust gas from the fixed pollution source. It is small in size, high in measurement accuracy, and easy to carry and install. With an independent flue gas sampling pipeline, it can measure the dynamic pressure, static pressure, temperature, flow rate, benchmark flow, etc. of the flue. It is widely used in environmental protection, testing companies, industrial and mining enterprises (power plants, iron and steel plants, cement plants, sugar plants, paper mills, smelters, ceramics plants, boiler kilns, as well as aluminum, magnesium, zinc, titanium, silicon, pharmaceutical industries, including fertilizer, chemical, rubber, material plants, etc.), health, labor, safety supervision, military, scientific research, education and other fields.
