ZKXQ-1 Automatic Vacuum Embedding Machine Introduction: Inlaying is a very important step in the preparation process of metallographic specimens, especially for small and difficult to handle samples, irregularly shaped samples that require edge protection, or samples that require automatic grinding and polishing. Inlaying of specimens is an essential process. The ZKXQ-1 vacuum inlay machine has a compact design, large capacity, simple and fast operation, and high equipment reliability. The built-in vacuum pump can quickly and effectively evacuate, suitable for vacuum cold embedding of epoxy resin. It can effectively remove bubbles in the sample and resin, allowing the resin to penetrate into the pores and cracks of the sample, obtaining a sample without bubbles and pores, and improving the final embedding effect of the sample. Very suitable for porous materials, such as the preparation of failure analysis specimens for cracks, porous castings, and composite materials, electronic components, rock minerals, ceramics, and other specimens. characteristic: 1. Built in low-noise vacuum pump, fast vacuum pumping speed, high vacuum degree 2. Fully transparent ultra large vacuum chamber, capable of holding up to 12 samples (40mm diameter) 3. Electric rotary table, manual knob pouring, convenient and fast 4. Program control, which can set the vacuum degree, cycle times, and corresponding time, automatically completes the entire embedding process of multiple samples, multiple vacuum extractions, maintaining vacuum, and releasing air cycles 5. According to different materials and samples, 80 sets of process parameters can be saved and called Technical parameters: Model: ZKXQ-1 Vacuum degree: 0~-75kPa, vacuum pump 0~-90kPa Vacuum flow rate: 10~20L/min Vacuum chamber size: Φ 250mm × 85mm Can simultaneously place 12 samples with a diameter of 40mm Work panel control: button jog, clockwise and counterclockwise directions Operation: 7-inch touch screen, manual knob pouring Timed cycle: 0-99min, automatic air extraction/release, automatic cycle Maximum number of cycles: 99 times Program saving: 80 sets Input power supply: single-phase 220V, 50Hz, 10A Dimensions: 462 × 400 × 310mm Net weight: 24KG
Introduction: Inlaying is a very important step in the preparation process of metallographic specimens, especially for small and difficult to handle samples, irregularly shaped samples that require edge protection, or samples that require automatic grinding and polishing. Inlaying of specimens is an essential process. The ZKXQ-1 vacuum inlay machine has a compact design, large capacity, simple and fast operation, and high equipment reliability. The built-in vacuum pump can quickly and effectively evacuate, suitable for vacuum cold embedding of epoxy resin. It can effectively remove bubbles in the sample and resin, allowing the resin to penetrate into the pores and cracks of the sample, obtaining a sample without bubbles and pores, and improving the final embedding effect of the sample. Very suitable for porous materials, such as the preparation of failure analysis specimens for cracks, porous castings, and composite materials, electronic components, rock minerals, ceramics, and other specimens.
