WKT-VST300 Thermal Deformation Vicat Softening Point Temperature Tester
Introduction: The WKT-VST300 touch thermal deformation and Vicat softening point temperature tester has the function of lifting and lowering the sample holder. The sample holder can be raised or lowered at the beginning or end of the test. The machine is mainly used for non-metallic materials such as plastics and rubber. Determination of heat distortion temperature and Vicat softening point temperature of nylon, electrical insulating materials, etc. The products meet the requirements of IS075(E), IS0306(E), GB/T8802, GB/T1633, GB/T1634 and other standards. WKT-VST300 is mainly used to measure the thermal deformation and Vicat softening point of non-metallic materials (such as plastic, rubber, nylon, and electrical insulating materials). It is widely used in the measurement of thermal deformation and Vicat softening point of plastics, rubber, nylon, electrical insulating materials, chemical building materials and other objects. Features: 1. Intelligent PID adjustment, accurate heating rate, accurate temperature control and no difference 2. It can do the thermal deformation test of various standard splines 3. Vicat softening point test of various standard splines can be done 4. Thermal deformation and Vicat softening point test can be performed at the same time 5. The required load can be automatically calculated according to the test standard and spline size 6. Two heating rates can be selected, free switching, simple operation 7. After the test is completed or the temperature exceeds the upper limit, the temperature control will be turned off automatically 8. There are software over-temperature protection and external mechanical over-temperature protection dual protection, so that the test has no worries Technical Parameters: Product model: WKT-VST300 Temperature control range: room temperature -300℃ Heating rate: (120±10)℃/h (12±1)℃/6min (50±5)℃/h (5±0.5)℃/6min Temperature display resolution: 0.1℃ Maximum temperature measurement error: ±0.5℃ Maximum deformation indication error: ±0.001mm Maximum deformation measurement range: 0-12mm Number of sample racks: 3 Heating medium: Methyl silicone oil (generally select 100 centistokes for kinematic viscosity) or transformer oil Maximum heating power: 4 kW Cooling method: air cooling above 150℃, water cooling below 150℃ Load bar-level pallet mass: 68g Power supply voltage: AC220V ±10% 50HZ
Introduction: The WKT-VST300 touch thermal deformation and Vicat softening point temperature tester has the function of lifting and lowering the sample holder. The sample holder can be raised or lowered at the beginning or end of the test. The machine is mainly used for non-metallic materials such as plastics and rubber. Determination of heat distortion temperature and Vicat softening point temperature of nylon, electrical insulating materials, etc. The products meet the requirements of IS075(E), IS0306(E), GB/T8802, GB/T1633, GB/T1634 and other standards. WKT-VST300 is mainly used to measure the thermal deformation and Vicat softening point of non-metallic materials (such as plastic, rubber, nylon, and electrical insulating materials). It is widely used in the measurement of thermal deformation and Vicat softening point of plastics, rubber, nylon, electrical insulating materials, chemical building materials and other objects.
