Introduction: The TQ-665 flange type torque sensor adopts the compact flange-flange connection design of the machine. One end of the rotor is installed at the transmission end and the other end is directly connected with the load end, which can be easily installed in the transmission system. In addition, a rotational speed measurement unit is built into the sensor. The flange type torque sensor can be directly installed on the transmission equipment. The stator ring is fixed on the outer ring of the rotating rotor and supported by the stator base. The sensor volume, size, material, measurement system and signal transmission are designed specifically for the harsh and complex working conditions on the engine test bench. Features: 1. TQ-665 strain-type flange torque sensor has a built-in digital measurement signal conditioning unit. Through non-contact transmission, the data is directly output in standard analog or digital signal mode. The rotor rotates in the stator ring, and no mechanical bearings are allowed, so there is no wear. 2. 0.5 or 0.1 precision level, optional voltage or frequency signal output 3. High-precision magnetoelectric angle/speed measuring unit, dust-proof and moisture-proof 4. Realize sensor parameter identification, setting, measurement and zero balance through RS-232C interface 5. The axial size is very small 6. Compact flange-flange connection design 7. Digital non-contact signal transmission 8. No bearing, no maintenance 9. System self-check function Technical parameter: Range: ±100N∙m… 300k Nm Overload capacity: 120% Output signal: 5-15KHZ; 0-10V; 4-20mA Accuracy grade: 0.5%; 0.25%; 0.1% Power supply: 24VDC Working speed: 0-15000 rpm Response frequency: 100μs Insulation resistance: ＞200MΩ Zero drift: <0.5% Repeatability: <0.1% Linearity: <0.1% Hysteresis: <0.1% Ambient temperature: -40-60℃ Relative humidity: <90%RH Operating temperature range: -10-70℃ Storage temperature range: -25-80℃ Sensor amplitude: 10V Sensor power consumption: ≈4W Sensor current consumption: 100MA Response time of strain gauge dynamic strain wave: 3.2X10-6s Sensor housing: strong anodized aluminum
Introduction: The TQ-665 flange type torque sensor adopts the compact flange-flange connection design of the machine. One end of the rotor is installed at the transmission end and the other end is directly connected with the load end, which can be easily installed in the transmission system. In addition, a rotational speed measurement unit is built into the sensor. The flange type torque sensor can be directly installed on the transmission equipment. The stator ring is fixed on the outer ring of the rotating rotor and supported by the stator base. The sensor volume, size, material, measurement system and signal transmission are designed specifically for the harsh and complex working conditions on the engine test bench.
