ThetaVAC-2 Vacuum Cold Embedding Machine Introduction: ThetaVAC-2 is a program-controlled vacuum cold embedding machine, which is lightweight and compact. It can be quickly and effectively evacuated by external compressed air or connected to a vacuum pump for vacuum cold embedding of epoxy resin. It has excellent pore impregnation function, which can quickly and effectively penetrate into small pores and cracks, ensuring edge protection and comprehensive filling of the sample. Very suitable for porous materials, such as the preparation of failure analysis specimens for cracks, porous castings, and composite materials, electronic components, rock minerals, ceramics, and other specimens. characteristic: (1) Program control, can set vacuum degree, cycle times, and corresponding time; (2) A super large vacuum chamber can hold up to 12 samples (40mm diameter); (3) Electric rotary table, convenient and fast pouring; (4) External high-pressure air, easy to operate, safe and reliable (can be equipped with a vacuum pump); (5) The inner wall is coated with Teflon, making it easy to clean. Technical parameters: 1. Model: ThetaVAC-2 2. Electrical Power supply: 100-240V, 50Hz, 35W (excluding vacuum pump) Control: 5-inch touch screen Timed cycle: timed range 0-10 minutes, automatic air extraction/release, automatic cycle Maximum number of cycles: 100 times Program: 20 sets 3. Vacuum Vacuum degree: 0~-80Kpa, vacuum pump 0~-90Kpa Maximum vacuum flow rate: 75 L/min Air consumption: 28-42 L/min Noise: 55-60dBA 4. Workplace Size: Inner diameter of Φ 252mm, can hold 12 samples of Φ 40mm at the same time Height: For molds with a diameter less than 100, the maximum height is 100mm; Molds with a diameter greater than 100 and a maximum height of 80mm Control: Button jog, direction: clockwise/counterclockwise 5. Operating environment Temperature: 0-60 ℃ Humidity: 0-95% RH 6. Gas supply Air pressure: OD=Φ 6mm trachea, recommended pressure 0.6~0.7MPa 7. External vacuum pump (optional) Voltage: Same as input voltage Power:<1000W Cable connector: National standard three core T-shaped male connector 8. Dimensions W × D × H: 497 × 461 × 293mm; 497 × 461 × 655mm (open lid) 9. Weight: 18kg
Introduction: ThetaVAC-2 is a program-controlled vacuum cold embedding machine, which is lightweight and compact. It can be quickly and effectively evacuated by external compressed air or connected to a vacuum pump for vacuum cold embedding of epoxy resin. It has excellent pore impregnation function, which can quickly and effectively penetrate into small pores and cracks, ensuring edge protection and comprehensive filling of the sample. Very suitable for porous materials, such as the preparation of failure analysis specimens for cracks, porous castings, and composite materials, electronic components, rock minerals, ceramics, and other specimens.
