Introduction: This tester is suitable for the determination of oxidative stability of distillate fuel oil by SH / T0175-2004 (Accelerated method) The middle distillate fuel oil with 90% recovery temperature not higher than 370 ℃ is determined. It is not suitable for fuel oil containing residual oil and synthetic fuel oil whose main component is non-petroleum component. Technical characteristics 1) with a joint black box, both for the test cooling, usually can also be used for storage of oxygen tube rack. 2) gas, water centralized supply, the gas and water were independently controlled. 3) heating and mixing equipment installed in a flat, easy maintenance. 4) the heater in the guide tube, so that the flow of water after the steady flow out to ensure that the temperature accuracy of the thermostat. Technical Parameters Thermostat Size: 500mm * 215mm * 450 (L * W * H) Dimensions: 840mm * 310mm * 1335mm (L * W * H) Test hole: 6 Heating power: 3.0KW (four groups of 750W heating tube) Air pressure adjustment range: 0.05 ~ 0.25MPa Flow regulation range: 10 ~ 100ml / min Thermostat Accuracy: room temperature +10 ~ 100 ℃ ≤ ± 0.2 ℃
Introduction: This tester is suitable for the determination of oxidative stability of distillate fuel oil by SH / T0175-2004 (Accelerated method) The middle distillate fuel oil with 90% recovery temperature not higher than 370 ℃ is determined. It is not suitable for fuel oil containing residual oil and synthetic fuel oil whose main component is non-petroleum component.
