Introduction: SWB-300E / F Vicat softening point & heat distortion temperature tester, is to determine the chemical fiber plastic (PE, PET, PP, nylon, etc.) and other samples of the heat distortion temperature Vicat softening point temperature and special equipment. In line with GB1633 thermoplastic softening point (Vicat) test method and GB1634 plastic bending load heat distortion temperature (referred to as heat distortion temperature) test method. By changing the different measuring head, respectively, for the measurement Vicat softening temperature or heat distortion temperature. They are one of the indicators of the determination of plastic heat resistance. The biggest advantage of the tester is that the temperature of the test is automatically memorized without the need for manual inspection during the test due to the effect of the elastic force of the displacement sensor. Dialysis / dial indicator with a resolution of 0.01mm / 0.001mm softens or deforms the test specimen. According to the standard value or calculated value, preset the amount of softening or deformation displacement, when a test unit displacement reaches the preset value, the unit of the temperature that is locked, three units have a total of three temperature test device. Test unit to be tested all end, send a signal, and automatically cut off the heating power. The instrument also provides users to calibrate the instrument itself, the thermal deformation of the standard sample stick, sample. Technical Parameters: Temperature range: room temperature ~ 300 ℃; heating rate: 5 ± 0.5 ℃ / 6min, 12 ± 1.0 ℃ / 6min; Temperature display accuracy: ± 0.5 ℃; temperature detection points: 3; Temperature distribution: ± 0.5 ℃; Bath volume: 25L; Number of test cells: 3; Deformation measuring device: dial indicator, 0.01mm; Thermal deformation indenter size: R = 3 ± 0.2mm; thermal deformation specimen fulcrum span: 100 ± 0.5mm; Softening point pressure needle size: 1.000 ± 0.015mm2 (d = 1.128 ± 0.0085mm); Load bar mass: 88.35g; Sample frame thermal deformation: ≤ 0.01mm, the correction value is given over; Heating power: 4kW Power: 220VAC, 20A Dimensions: 830500540 mm3 (length, width and height) Machine weight: E type 58kg (excluding heating oil) / F type 63kg (excluding heating oil)
Introduction: SWB-300E / F Vicat softening point & heat distortion temperature tester, is to determine the chemical fiber plastic (PE, PET, PP, nylon, etc.) and other samples of the heat distortion temperature Vicat softening point temperature and special equipment. In line with GB1633 thermoplastic softening point (Vicat) test method and GB1634 plastic bending load heat distortion temperature (referred to as heat distortion temperature) test method. By changing the different measuring head, respectively, for the measurement Vicat softening temperature or heat distortion temperature. They are one of the indicators of the determination of plastic heat resistance. The biggest advantage of the tester is that the temperature of the test is automatically memorized without the need for manual inspection during the test due to the effect of the elastic force of the displacement sensor. Dialysis / dial indicator with a resolution of 0.01mm / 0.001mm softens or deforms the test specimen. According to the standard value or calculated value, preset the amount of softening or deformation displacement, when a test unit displacement reaches the preset value, the unit of the temperature that is locked, three units have a total of three temperature test device. Test unit to be tested all end, send a signal, and automatically cut off the heating power. The instrument also provides users to calibrate the instrument itself, the thermal deformation of the standard sample stick, sample.
