Introduction: All disinfection pipettes can be 121 ℃, 1atm under the conditions of the whole high temperature and pressure disinfection for 20 minutes, no special preparation can be the whole disinfection. Dispose of more than 12 hours after disinfection to allow it to cool and dry. It is recommended to check the performance of the pipette after each full high temperature and pressure disinfection. It is also recommended that every 10 times the high temperature and pressure disinfection to the pipette after the re-piston and lubricant on the seal. Dragon each pipette in the factory in accordance with the requirements of ISO8655 made factory inspection and calibration, the declared inaccuracy and accuracy are better than ISO8655 standard. Pipettes in use during the course of a variety of reasons will cause bias, regular calibration is an important means to ensure its accuracy. Features: 1 nozzle ejector can also launch multi-channel nozzle, efficient and effort 2 Various ranges of 8 and 12 pipettes are available for standard 96-well plates 3 liquid head can be rotated 360 degrees, easy to pipetting 4 each nozzle fittings have a separate piston device, easy maintenance 5 special nozzle fittings design, easy to observe the nozzle of the sealing situation Technical indicators: Range: 0.1-2.5 μl Increment: 0.05 μl Measurement volume (μl): 2.5 Allow maximum system error (inaccuracy)%: 2.50% Μl: 0.0625 Allow maximum random error (inaccuracy)%: 2.00% μl: 0.05
Introduction: All disinfection pipettes can be 121 ℃, 1atm under the conditions of the whole high temperature and pressure disinfection for 20 minutes, no special preparation can be the whole disinfection. Dispose of more than 12 hours after disinfection to allow it to cool and dry. It is recommended to check the performance of the pipette after each full high temperature and pressure disinfection. It is also recommended that every 10 times the high temperature and pressure disinfection to the pipette after the re-piston and lubricant on the seal. Dragon each pipette in the factory in accordance with the requirements of ISO8655 made factory inspection and calibration, the declared inaccuracy and accuracy are better than ISO8655 standard. Pipettes in use during the course of a variety of reasons will cause bias, regular calibration is an important means to ensure its accuracy.
