M8001 metal analyzer Brief introduction:
The instrument is domestic first USES a metre focal length grating photoelectric direct reading spectrometer, equipped with advanced practical factory calibration curve. M8001 metal analyzer can be widely used in metallurgy, casting, machinery, metal processing and so on in the field of process control, finished goods inspection center laboratory, such as Fe, Al, Cu, Mg and other metal and its alloy material analysis. Features:
1. The optical system:
Using a meter focal length, palmer XingLong lattice structure, the dispersion effect is good;
Use high signal-to-noise ratio, low dark current, large diameter long life photomultiplier tubes (Φ 28 mm);
Photomultiplier tube outer, to avoid the photomultiplier high-pressure glow discharge to the data acquisition system damage;
2. Digital light source:
Excitation parameters controlled by computer;
Have main back to passing electric current protection function, can avoid caused by wrong operation instrument damage;
The solution of the single spark discharge control technology to achieve the element analysis and application of ci functions;
3. Sample excitation sets:
With special structure and material design, to avoid the overheating temperature influence on the results of the analysis;
Reasonable argon gas circuit design, make the samples when argon gas flushing time, for the user to save the argon consumption;
Special structural design, can be in the process of sample excitation, the effective screening background light, to improve the signal-to-noise ratio of instrument;
4. System monitoring:
Can real-time monitor the light chamber temperature and vacuum, argon pressure, light source, excitation room state, critical voltage value, etc.;
Can be displayed on the screen (or remote GPRS transmission) system status monitoring report;
The automatic instruments and abnormal state protection and prompt functions. Technical parameters:
Focal length: 1000 mm
Grating groove: 2160 gr/mm
Line dispersion rate: 47 nm/mm (level 1)
Incident slit: 20 microns
Exit slit: 25-90 microns
Analysis of channel: up to 48
Testing time: no more than 40 seconds
Vacuum degree: 10 pa or less
Power requirements: AC220V plus or minus 10%, 50 hz
The average power consumption: sample excitation power 2 kva
Argon gas: a purity of 99.995% or more
The argon gas flow: inspire for 3 to 5 L/min, standby at 0.5 L/min
Working temperature: 15-30 ℃
Ambient temperature: 0-45 ℃
Relative humidity: less than 80%
Dimensions: length 1700 (inspire) X 1000 X 1000 mm wide
Instrument weight: 580 kg
Brief introduction:
The instrument is domestic first USES a metre focal length grating photoelectric direct reading spectrometer, equipped with advanced practical factory calibration curve. M8001 metal analyzer can be widely used in metallurgy, casting, machinery, metal processing and so on in the field of process control, finished goods inspection center laboratory, such as Fe, Al, Cu, Mg and other metal and its alloy material analysis.
