LDGC-MIK plug-in electromagnetic flowmeter Introduction: LDGC-MIK plug-in electromagnetic flowmeter is used in various departments such as industry, agriculture, water conservancy, environmental sewage monitoring, urban water supply, etc. to measure the flow rate and total amount of various conductive liquids. Compared to pipeline flow meters, the measurement of plug-in electromagnetic flow meters is not affected by changes in fluid density, viscosity, temperature, pressure, and conductivity. Adopting advanced excitation technology, low power consumption, stable zero point, strong anti-interference ability, and good reliability. No additional pressure loss, requires a small length of straight pipe section, and relatively simple installation. The measurement range is wide, and the full range flow rate can be continuously and arbitrarily set within 1.0m/s-10.0m/s. The output signal is completely linear with the flow rate (flow rate). Features: 1. The conversion display adopts a 16 bit high-performance microprocessor, with a 2x16 LCD display, convenient parameter setting, and reliable programming 2. Bidirectional measurement system, equipped with three integrators that can respectively display the total amount of forward flow, reverse flow, and the difference between forward and reverse flow 3. The conversion display has multiple outputs: current, pulse, digital communication, and Hart 4. Suitable for large diameter pipelines, DN100-3000mm 5. The sensor body and electrodes have multiple materials to choose from 6. Small size, light weight, convenient transportation and installation, capable of continuous maintenance and disassembly 7. Cheap price, the larger the installation diameter, the higher the performance price ratio Technical parameters: 1. Applicable flow rate pipeline nominal diameter: DN100-3000mm. 2. Work pressure: ≤ 1.6MPa 3. Working temperature: ≤ 60 ℃ 4. Upper limit range of flow rate: continuously adjustable within 1-10m/s 5. Measurement accuracy: ± 1.5% 6. The conductivity of the tested medium is ≥ 30 μ S/cm. 7. Electrode materials: 316L, Hastelloy, titanium (Ti), etc 8. The maximum distance from the conversion display is ≤ 50m. 9. Cable: RVVP type double core shielded cable or STT3200 type four core three shielded cable.
Introduction: LDGC-MIK plug-in electromagnetic flowmeter is used in various departments such as industry, agriculture, water conservancy, environmental sewage monitoring, urban water supply, etc. to measure the flow rate and total amount of various conductive liquids. Compared to pipeline flow meters, the measurement of plug-in electromagnetic flow meters is not affected by changes in fluid density, viscosity, temperature, pressure, and conductivity. Adopting advanced excitation technology, low power consumption, stable zero point, strong anti-interference ability, and good reliability. No additional pressure loss, requires a small length of straight pipe section, and relatively simple installation. The measurement range is wide, and the full range flow rate can be continuously and arbitrarily set within 1.0m/s-10.0m/s. The output signal is completely linear with the flow rate (flow rate).
