Introduction: GSL-1700X-SPC-2 small-scale program temperature-controlled evaporation coating instrument can set the program, and accurately control the temperature of 200oC-1500oC (or 1200oC-1700oC), the largest vaporizable diameter of 2" thin film sample, the sample table can be rotated to A more uniform thin film can be obtained, various metal thin films and organic thin films can be prepared, which are widely used for the preparation of electrodes and organic light-emitting LEDs. Features: 1, has passed CE certification. 2, using quartz cavity, easy to clean and put the sample. 3, the sample stage can be rotated, can make the film to achieve better uniformity. 4. Using tungsten wire as a heat source, the maximum temperature can reach 1700°C, and a special alumina boat loading sample (only used below 1600°C, if the evaporation temperature is greater than 1600°C, the sample should be placed directly in the tungsten wire basket). The 5. The thermocouple is installed at the bottom of the crucible to facilitate temperature measurement and control. 6, the device can be converted to manual adjustment, the internal thermocouple is not installed, the direct use of manual adjustment of the output current size, heat source temperature up to 2000oC, can reach the experimental requirements of the sample carbon plating. 7. Inert gas may be introduced into the vacuum chamber to clean the chamber, and reactive gas may also be introduced to perform reaction evaporation deposition. 8, the inlet is equipped with a needle valve, used to adjust the intake flow. Technical Parameters: 1. Voltage: AC 208V-220V 50Hz/60Hz Single Phase 2, the maximum power: 500W, the maximum current of 30A 3, vacuum chamber: quartz chamber, diameter Ø6" 4, sample stage: diameter Ø50mm; rotatable, speed 5rpm; adjustable distance from the evaporation source, adjustment range 60mm-100mm 5, the maximum temperature: 1700oC 6, thermocouple: S-type thermocouple, working temperature 200oC-1500oC (optional type B thermocouple, working temperature 1200oC-1700oC) 7, temperature control accuracy: ± 1oC, digital temperature controller, can be set to 30 sections of temperature program 8, tungsten basket: 2 9, vacuum interface: KF40 10. Vacuum gauge: digital anti-corrosion vacuum gauge PCG554, measuring range 3.8×10-5-1125 torr 11, intake interface: 1/4NPS Size: 440mm × 330mm × 630mm Optional accessories 1. Mechanical pump (with oil filter) (vacuum degree <10-2torr, can evaporate precious metals, such as Au, Ag) 2. Molecular pump (high vacuum available, vacuum degree <10-5torr, evaporation of easily oxidized materials such as Al, Mg, Li, etc.) 3, low vacuum system 4, high vacuum system 5, plasma cleaning machine (cleaning the substrate before coating, get better film strength)
Introduction: GSL-1700X-SPC-2 small-scale program temperature-controlled evaporation coating instrument can set the program, and accurately control the temperature of 200oC-1500oC (or 1200oC-1700oC), the largest vaporizable diameter of 2" thin film sample, the sample table can be rotated to A more uniform thin film can be obtained, various metal thin films and organic thin films can be prepared, which are widely used for the preparation of electrodes and organic light-emitting LEDs.
