Brief introduction: Walk-in constant temperature and humidity laboratory series product is suitable for large parts, semi-finished products and finished products and pharmaceuticals to accelerate, alternating hot and humid test, humid heat test constant humid heat test and routine test can also do high and low temperature, low temperature storage, so that the product in the experiment the proposed environmental condition, the performance and behavior to make analysis and evaluation. Features: 1. Use the library board unit combination, internal volume can be arbitrary amplification, tear open outfit is convenient, can design according to customer request size. 2. The library board SUS# 304 stainless steel material, external use SECC lengzha steel plate processing of the lacquer that bake, beautiful and easy; Insulation layer using PU foam or rock wool. 3. The control system adopts imported single point or programmable controller, man-machine interface, can be arbitrarily set, easy to use. 4. USES binary type low temperature circuit system design, and in different WenYu different compressor work, in order to increase the service life of the equipment. 5. The inner is equipped with large viewing window, easy to observe the test the test status of the sample. 6. On the left side of the body with a diameter of 50 mm test hole, used for external test power supply cord or signal lines. 7. Using high quality centrifugal fan power supply air circulation, to avoid any dead space, can make the uniform temperature distribution in the test area. 8. Equipped with advanced security and protection system - leakage circuit breakers and overtemperature protector, lack of phase protector, water protector Technical indicators: Model: DY - 10-0 a Test area scale: 270 * 210 * 210 cm Installation dimensions: 235 * 260 * 260 cm Operating temperature range: ESTH: + 85 ℃ (100 ℃, 120 ℃ ~ 65 ℃ (A: 0 ℃, B: - 20 ℃, C: to 40 ℃, D: - 65 ℃). Range of relative humidity: 30% ~ 95% RH Temperature fluctuation degree, plus or minus 0.5 ℃ or less Heating time: 60 min or less The cooling time: 30 min ~ 180 min (depending on the different types and different) Temperature and humidity control system: Germany imported from a closed or semi-closed compressor, refrigerant R404a/R23, axial flow fan Controller: adopts Siemens PLC controller, standard for OYO digital display series; Display precision of temperature: 0.1 ℃, Watch window: hollow multilayer electroplating film heat explosion proof glass Power: AC380 ℃ (1 + / - 10%) V, 50 + / - 0.5 HZ, three phase four wire + ground protection
Walk-in constant temperature and humidity laboratory series product is suitable for large parts, semi-finished products and finished products and pharmaceuticals to accelerate, alternating hot and humid test, humid heat test constant humid heat test and routine test can also do high and low temperature, low temperature storage, so that the product in the experiment the proposed environmental condition, the performance and behavior to make analysis and evaluation.
