Introduction: It is used for the measurement of the adhesion between the CCL and the metal layer of the printed circuit board and the substrate, complies with IEC-326-2 "Test Method for Printed Circuit Board" 7.1, GB / T4677-2002 7.1.1, GB / T 13557-92; IPC-TM-650 2.4.9 standard. Features: 1, patented design, elegant appearance. 2, using Aida high-quality rally meter header, high measurement accuracy. 3, with N, kg, lb three units free conversion. 4, soft and hard board design, free to change the test fixture. 5, measurable force maximum, minimum, average and so on. 6, with special software, printer can link the curve of the printer. Technical Parameters: Model: BL12 The maximum travel: 58mm Maximum pulling force: 5kgf (or 49N or 11lbf) Measurement accuracy: ± 0.1N (calculated by 49) Measurement speed: 50.8 ± 2.5mm / min Rated voltage / current / power: 220V ~ 50Hz / 0.1A / 20W
Introduction: It is used for the measurement of the adhesion between the CCL and the metal layer of the printed circuit board and the substrate, complies with IEC-326-2 "Test Method for Printed Circuit Board" 7.1, GB / T4677-2002 7.1.1, GB / T 13557-92; IPC-TM-650 2.4.9 standard.