Brief introduction: Wire and cable into a bundle of burning tester according to the standard of wire and cable of bundles UL1685, GB18380.3 fire test requirements and other relevant regulations and design of the equipment. And conform to the IEC 60332-3-10, KS C IEC 60332-3-21 ~ 25 (A ~ D class) standard. Into a bundle of wire and cable combustion tester is used to detect the vertical installation into cable or optical cable under prescribed conditions inhibit the ability of vertical flame spread of instrument, is the power cable, control cable, fiber optic cable and other necessary into a bundle of burning test device. When supply box body and a certain amount of gas using standard fire ignition, this instrument can be used to test the vertical flame spread to the electric vertical fire vertical state of cables and wires. In addition, if the tester burner adjustment 20 degrees, can achieve the IEEE 383 (IEEE 1202) testing standards. Equipment can be added with heat release instrument configuration port, thermodynamic values can be measured with gas analysis device, such as H.R.R (heat release rate), S.P.R (rate of smoke generated), etc. Features: 1. Intelligentize degree is high, the operation is simple; 2. Professional industrial design, beautiful, generous. 3. Equipment precision, safety and stability; 4. Microcomputer control system, intelligent test process; No manual timing and related operations; 5. Stainless steel corrosion resistance box; Technical parameters: Test the size of the box: 1000 + 100 (W) x 2000 + 100 (D) x 4000 + 100 mm (H) Anemometer precision: 0.1 m/s; Air source air meter range: 8000 l/min; Outlet wind speed (5000 + 500) L/min can be adjusted; Gas: technical grade of purity 95% propane () by advertisers Gas flow control: 100 kpa, 20 ℃ condition The combustion air supply: propane (or liquefied petroleum gas). The console size: 600 (W) x 750 x 1600 mm (H) (D) Power supply: AC 220 v, 50/60 hz, 15 a Weight: 1500 kg
Brief introduction: Wire and cable into a bundle of burning tester according to the standard of wire and cable of bundles UL1685, GB18380.3 fire test requirements and other relevant regulations and design of the equipment. And conform to the IEC 60332-3-10, KS C IEC 60332-3-21 ~ 25 (A ~ D class) standard. Into a bundle of wire and cable combustion tester is used to detect the vertical installation into cable or optical cable under prescribed conditions inhibit the ability of vertical flame spread of instrument, is the power cable, control cable, fiber optic cable and other necessary into a bundle of burning test device.