TRTQ-3A type hydrocarbon element analyzer Introduction: The TQ series hydrocarbon element analyzer is designed and manufactured according to the international standards 1SO625:1996 (E) "Solid Mineral Fuels - Determination of Hydrocarbons - Libyan Method" and GB/T 476-2008 "Method for Determination of Carbon and Hydrogen in Coal". It is used by laboratories in coal, chemical, metallurgical, power, and geological exploration departments to determine the content of "carbon" and "hydrogen" elements in coal and other organic matter. The tested sample burns in an oxygen stream under high temperature conditions to generate water and carbon dioxide, which are absorbed separately by water absorbent and carbon dioxide absorbent. The percentage content of carbon and hydrogen is calculated based on the weight gain of the absorbent. The accuracy meets the requirements of GB/T476. characteristic: 1. Determination of carbon and hydrogen content in coal or other organic matter by absorption mass method; 2. Three stage independent automatic constant temperature control system, which can set and control different temperatures separately; 3. Digital temperature display, intuitive, accurate, stable and reliable performance; 4. Can simultaneously measure two samples; 5. The overall structure design is reasonable, the appearance is beautiful, the operation is convenient, and the maintainability is good. Technical parameters: Measurement range: Carbon (1-100)%, Hydrogen (0-20)% Temperature measurement accuracy: 0.2 level; Temperature control range: 0-1100 ℃; Temperature control accuracy: ± 10 ℃; Furnace length: one section furnace length: 230mm; Two section furnace length: 330mm; Three furnace lengths: 150mm. Furnace diameter: 34mm. Furnace temperature: One furnace temperature control: 850 ℃; Two section furnace temperature control: 800 ℃; Three section furnace temperature control: 600 ℃. Rated power: 1200W per furnace; Two section furnace 1500W; Three furnace 800W. Combustion tube: 2 stainless steel tubes, with an outer diameter of 24mm, an inner diameter of 20mm, and a length of 1200mm. Heating element: Nickel chromium wire with a diameter of 0.6 to 1.0mm is wound in a spiral shape. Temperature control system: digital temperature display regulator, automatic constant temperature from 0 to 1100 ℃. Measuring element: Nickel chromium nickel silicon (K-type) thermocouple, with a division value of 0-1000 ℃. Power supply: 220V ± 10% 50Hz. Dimensions: 1200 × 320 × 580mm. Weight: 60kg
Introduction: The TQ series hydrocarbon element analyzer is designed and manufactured according to the international standards 1SO625:1996 (E) "Solid Mineral Fuels - Determination of Hydrocarbons - Libyan Method" and GB/T 476-2008 "Method for Determination of Carbon and Hydrogen in Coal". It is used by laboratories in coal, chemical, metallurgical, power, and geological exploration departments to determine the content of "carbon" and "hydrogen" elements in coal and other organic matter. The tested sample burns in an oxygen stream under high temperature conditions to generate water and carbon dioxide, which are absorbed separately by water absorbent and carbon dioxide absorbent. The percentage content of carbon and hydrogen is calculated based on the weight gain of the absorbent. The accuracy meets the requirements of GB/T476.
