SY-6601 cable identification instrument Introduction The cable identification instrument is a special instrument developed by our company according to the special needs of the power industry. The cable identification instrument is used to determine the running condition of the cable (ie, whether it is a live running cable or a stop cable) in the erection, migration, maintenance and fault handling of the power cable; to identify the cable to be found in the power outage cable; Fast, easy to operate, and wide range of applications. It is the newest type of instrument with the most advanced technology and superior performance in the domestic similar instruments. The cable identification instrument consists of a signal generator and a receiving clamp and a signal detector. The signal generator mainly generates a special pulse modulation signal, which is added to the tested cable that stops running through the output line, and is used to find the measured device with the receiving clamp. Cable, when the receiving clamp detector detects a special signal applied to the cable, the signal detector pointer of the signal detector oscillates synchronously with the frequency of the applied signal, while the signals detected on other cable lines are much smaller and opposite directions, indicated by the meter The amplitude and direction make it easy to determine the cable under test. When the receiving clamp and the signal detector are used in combination with the signal generator, they can be used for cable charging state discrimination or assisting in finding the cable short-circuit position. When using the receiving pliers, the cable should be clamped with the jaws. Features: Accurate identification Large jaws for various cables Simple and clear operation Clear and unambiguous judgment The whole set of instruments is small and beautiful The whole machine works reliably and is not afraid of short circuit Output height adjustable, suitable for all occasions Technical Parameters: Signal generator: Power supply: AC220V 50Hz Output power: 1KVA Output mode: Clearance modulation Gap time: 1-2S Ambient temperature: -10—45 c°
Receiver and signal detector: Power: no Detection current: 5A ~ 40A Detection method: clamping type, direction and size Jaw: ≥140mm, inner diameter ≥120mm when closed
Introduction The cable identification instrument is a special instrument developed by our company according to the special needs of the power industry. The cable identification instrument is used to determine the running condition of the cable (ie, whether it is a live running cable or a stop cable) in the erection, migration, maintenance and fault handling of the power cable; to identify the cable to be found in the power outage cable; Fast, easy to operate, and wide range of applications. It is the newest type of instrument with the most advanced technology and superior performance in the domestic similar instruments. The cable identification instrument consists of a signal generator and a receiving clamp and a signal detector. The signal generator mainly generates a special pulse modulation signal, which is added to the tested cable that stops running through the output line, and is used to find the measured device with the receiving clamp. Cable, when the receiving clamp detector detects a special signal applied to the cable, the signal detector pointer of the signal detector oscillates synchronously with the frequency of the applied signal, while the signals detected on other cable lines are much smaller and opposite directions, indicated by the meter The amplitude and direction make it easy to determine the cable under test. When the receiving clamp and the signal detector are used in combination with the signal generator, they can be used for cable charging state discrimination or assisting in finding the cable short-circuit position. When using the receiving pliers, the cable should be clamped with the jaws.
