Introduction: ST-1563 trace residual carbon analyzer is designed and manufactured according to GB/T17144, ASTM D4530 and ISO10370 standards. It has beautiful appearance and convenient operation. It is used to determine the residue formed by evaporation and pyrolysis of petroleum products under specified conditions. The test results are consistent with the GB/T268 (Kang's) test results. Applicable to petrochemical, building materials, metallurgy, scientific research units, commodity inspection and university laboratories. Features: 1. Test with only a small amount of sample 2. Import programmable temperature controller for temperature monitoring 3. Use nitrogen to protect the airflow to ensure good repeatability and reproducibility 4. Automatic monitoring of nitrogen pressure, automatic flow control, automatic alarm at the end of the experiment 5. The exhaust gas is discharged by the tracheal derivation method, and the requirements of the experimental site are more flexible and flexible compared with the Kang's method. 6. Can measure 12 samples simultaneously 7. Cooling with an axial fan helps the instrument cool down 8. All experimental procedures are automatically tested by the instrument. After the experiment is over, the buzzer prompts the end of the experiment. 9. Nitrogen shutdown automatically cuts off, no inadvertent leakage of nitrogen Technical Parameters Adaptation standards: GB/T17144, ASTM D4530, ISO10370 Temperature control point: 500 ° C Temperature control accuracy: ±2 °C Working pressure: 0.15Mpa Air source pressure: 1st level pressure *** 2MPa, 2nd level pressure *** 0.5Mpa Nitrogen flow rate: 150mL/min 600mL/min (according to GB/T17144) Power consumption: heating power 950W Working time: about 120min Maximum number of experiments: 12 times Power source: 220V±10% 50Hz Ambient temperature: 5 ° C ~ 45 ° C Relative humidity: 10%～80% Rh Dimensions: 382 × 408 × 575mm
Introduction: ST-1563 trace residual carbon analyzer is designed and manufactured according to GB/T17144, ASTM D4530 and ISO10370 standards. It has beautiful appearance and convenient operation. It is used to determine the residue formed by evaporation and pyrolysis of petroleum products under specified conditions. The test results are consistent with the GB/T268 (Kang's) test results. Applicable to petrochemical, building materials, metallurgy, scientific research units, commodity inspection and university laboratories.
