Introduction: Simulation of impact and collision (continuous impact) tests to determine the suitability of the tested product to withstand or multiple repeated mechanical impacts during use, handling, and transportation, to assess the integrity of its structure and to inspect the packaging instrumentation during transport. Sustained continuous impact integrity. This product meets the test requirements of GB/T 2423 and other standards. Features: 1. Use computer to control the collision table and measure the acceleration signal to realize the automation of operation; 2. Impact, frequency of collision can be adjusted according to the user input frequency, the impact of the operation is convenient; 3. The test time and the number of impacts can be set. After the test is completed, it will be automatically shut down to facilitate the user's operation; 4 The conversion time in the low temperature zone and high temperature zone is less than or equal to 15 seconds. 5 The temperature recovery time is less than or equal to 5 minutes. Technical Parameters: Maximum load: 100kg Table size: 500×700mm Dimensions: 900×700×1240mm Maximum collision frequency: 80 beats/min Maximum drop height: 60mm Power: 2000VA Table body mass: 1100kg Power supply: 220V 50HZ
Introduction: Simulation of impact and collision (continuous impact) tests to determine the suitability of the tested product to withstand or multiple repeated mechanical impacts during use, handling, and transportation, to assess the integrity of its structure and to inspect the packaging instrumentation during transport. Sustained continuous impact integrity. This product meets the test requirements of GB/T 2423 and other standards.
