Introduction: SDHg3000 mercury analyzer is suitable for trace analysis of mercury in samples. Comply with standard SN/T3521-2013 "Simultaneous determination of arsenic and mercury content in imported coal by hydride generation-atomic fluorescence spectrometry" GB/T 16659-2008 "Method for determination of mercury in coal" Features: 1. The sample is pre-treated by wet digestion, which has high test accuracy and low cost. 2. The test component atomic fluorescence photometer has superior performance: each system is highly integrated, easy to replace and maintain, only a small amount of accessories can be reserved; a new type of air-tight secondary gas-liquid separation device is adopted, without adding liquid and discharging waste. 3. Supporting calculation software: a software specially designed to solve customer calculation and statistics problems. It can import the concentration data in the atomic fluorescence photometer, and can be connected to the weighing manager to directly enter the sample quality data and calculate the coal with one click The results of mercury in the coal can be associated with the fluorine and chlorine analyzer to export all the data of fluorine, chlorine, mercury, arsenic, and phosphorus in coal samples according to customer requirements. technical parameter Detection limit DL: Hg＜0.001μg/L Relative standard deviation RSD: <0.8% Mercury test range: 0~10ppm; Mercury repeatability: ≤0.06ppm Sample pretreatment time: 6h Test time: 1min/sample
Introduction: SDHg3000 mercury analyzer is suitable for trace analysis of mercury in samples. Comply with standard SN/T3521-2013 "Simultaneous determination of arsenic and mercury content in imported coal by hydride generation-atomic fluorescence spectrometry" GB/T 16659-2008 "Method for determination of mercury in coal"
