Product overview: SD-WK-H (TH) this product USES internationally advanced sensors to monitor and sample the temperature of the working environment automatically for a long time. When the working environment temperature is low (high) at the set temperature value, the corresponding heating (cooling) load will be turned on immediately, and the work will stop until the ambient temperature reaches the set requirement, and the monitoring state will be re-entered, so repeated automatic cycle. Main application areas: Sd-wk-h (TH) can be used in various high-low voltage switchgear, terminal box, box-type substation, isolation switch, circuit breaker body box and other occasions that need to control equipment environmental temperature, so as to protect and guarantee the safety of power equipment operation, reduce costs and improve economic benefits. Energy management system Maio automation Power monitoring in the town Automation of electric substation Fish hatching site Automation of distribution network Intelligent architecture Is the intelligent switchboard, switch cabinet aquaculture File room, warehouse Technical indicators: Main power supply: AC220V x (80 ~ 110%),50Hz Bring about the use of the environment (monitor) : 25 ~ + 65 ℃ temperature, relative humidity 95% RH or less Bring about temperature control range: cooling type 0 ~ 95 ℃, the temperature type - 40 ~ 55 ℃ Bring about temperature control precision: + / - 1 ℃ Step response speed: the typical value is less than or equal to 5s Pin output: 1 time working voltage, rated power resistance load AC220V 3A normally open No power consumption: 1.2w Compression resistance: 2KV 50Hz 3min To prevent acid, alkali and salt gas damage Cheng volume: 48 x 48 x 78mm3 Bring back the poor: + 10 ℃
Product overview: SD-WK-H (TH) this product USES internationally advanced sensors to monitor and sample the temperature of the working environment automatically for a long time. When the working environment temperature is low (high) at the set temperature value, the corresponding heating (cooling) load will be turned on immediately, and the work will stop until the ambient temperature reaches the set requirement, and the monitoring state will be re-entered, so repeated automatic cycle.
