Introduction: The gear friction wear tester is a multipurpose tester. It can be used for the assessment of the bearing capacity of lubricants, and can also be used for special orders according to the needs of users. It can be used for the test of the gluing and bearing capacity of gear pairs and the bearing capacity of gears. Related standards: GB/T13672-92 "Test method for gear gluing load carrying capacity (CL-100 gear machine method)" SH/T0306-92 Determination of Lubricant Carrying Capacity The machine is a power closed-loop structure, and the loading method adopts a loading rod hanging weight. The loading rod is hung on the sheave of the loading clutch, and after the weight is added, the two sheaves on the loading clutch are tightened by tightening the nut of the loading clutch, and the weight and the loading rod are removed, and the torque measuring clutch can be used. Read out the torque. The heating of the sample and the temperature control are achieved through the temperature control table and the power regulator. On the right side of the temperature control table, there is a switch, which is turned to the "on" side. The temperature control table is turned on and turns off to the "off" side. The temperature control table disconnects the power supply. The power conditioner switch operation is the same. Through the setting of the temperature control table and the operation of the power conditioner, the test temperature can be controlled. After the instrument is plugged in the power cord, press the "ON" button on the power supply part, the entire machine is powered on; press the "OFF" button on the power supply part, the entire machine is in a power off state; after pressing the "ON" button on the power supply section Press the "Low Speed" button, the motor will run at 1450r/min; press the "motor stop" button, the motor will stop running. Technical Parameters: Technical Name: Gear Wear Tester Parameters Maximum torque: 1kN. m Maximum load level: 13 Temperature control accuracy: ±2oC Drive motor power: 6.5/8kw Drive motor speed: 1450/2880r/min, stepless adjustable Test gearbox capacity: 1.25L Heating power: 0.5×3=1.5kw Host Dimensions: 1390×705×1082mm
Introduction: The gear friction wear tester is a multipurpose tester. It can be used for the assessment of the bearing capacity of lubricants, and can also be used for special orders according to the needs of users. It can be used for the test of the gluing and bearing capacity of gear pairs and the bearing capacity of gears. Related standards: GB/T13672-92 "Test method for gear gluing load carrying capacity (CL-100 gear machine method)" SH/T0306-92 Determination of Lubricant Carrying Capacity The machine is a power closed-loop structure, and the loading method adopts a loading rod hanging weight. The loading rod is hung on the sheave of the loading clutch, and after the weight is added, the two sheaves on the loading clutch are tightened by tightening the nut of the loading clutch, and the weight and the loading rod are removed, and the torque measuring clutch can be used. Read out the torque. The heating of the sample and the temperature control are achieved through the temperature control table and the power regulator. On the right side of the temperature control table, there is a switch, which is turned to the "on" side. The temperature control table is turned on and turns off to the "off" side. The temperature control table disconnects the power supply. The power conditioner switch operation is the same. Through the setting of the temperature control table and the operation of the power conditioner, the test temperature can be controlled. After the instrument is plugged in the power cord, press the "ON" button on the power supply part, the entire machine is powered on; press the "OFF" button on the power supply part, the entire machine is in a power off state; after pressing the "ON" button on the power supply section Press the "Low Speed" button, the motor will run at 1450r/min; press the "motor stop" button, the motor will stop running.
