PLR-SPRL experimental flat plate photochemical reaction device Introduction: Due to the fact that most photocatalytic reactors are currently completed in kettle reactors, there are significant differences in the design and use of flat plate reactors compared to kettle reactors, and the research results of kettle reactors cannot be directly applied to experiments on flat plate reactors. The PLR-SPRL experimental flat plate photochemical reaction device has a small reactor volume and is mainly used for: 1. validating the selected experimental methods and basic process conditions; 2. Obtain necessary physical, thermodynamic, and kinetic data; 3. Study the impact of the transmission process. characteristic: 1. The reactor has a compact volume with an effective working area of 10 × 10 cm2, and can be selected from 5 × 5, 15 × 15, 20 × 20, and 25 × 25 cm2. Experimenters can change different reactors according to the experimental situation, gradually increase the reaction area, and obtain mass transfer, heat transfer, and reaction kinetics data during the amplification process. 2. The support block design can be replaced to fix substrates made of various materials such as non-woven fabric, carbon paper, carbon cloth, high borosilicate glass, organic glass, etc., to meet the loading requirements of different catalysts. 3. It has a water bath temperature control structure, which can timely remove the heat during the reaction process by circulating condensed water. 4. It can undergo closed or continuous flow reactions. When the efficiency is low in the early stage of the experiment, a closed reaction is chosen to measure the activity of the catalyst through time accumulation. With the optimization of the process and the increase of production, the continuous flow mode can be switched to characterize the activity of the catalyst. 5. The device comes with a manual injection valve, which can be directly combined with gas chromatography to achieve online detection of products. Technical parameters: Effective illumination area: 10 × 10 cm2, optional 5 × 5, 15 × 15, 20 × 20, 25 × 25 cm2 Liquid layer thickness: 1-5 mm or customized according to specifications Contact material of reaction solution: PA66、PMMA、PP、 Fluororubber, etc Reactor angle adjustment: 0~90 ° Liquid flow rate range: 0~1 L/min Range of carrier gas flow rate: 4~100 mL/min Reaction temperature: room temperature~60 ℃ Reaction pressure: atmospheric pressure Gas circulation pump flow rate: 1~1.5 L/min Reaction temperature: room temperature~60 ℃ Reaction pressure: ≤50 kPa
Introduction: Due to the fact that most photocatalytic reactors are currently completed in kettle reactors, there are significant differences in the design and use of flat plate reactors compared to kettle reactors, and the research results of kettle reactors cannot be directly applied to experiments on flat plate reactors. The PLR-SPRL experimental flat plate photochemical reaction device has a small reactor volume and is mainly used for: 1. validating the selected experimental methods and basic process conditions; 2. Obtain necessary physical, thermodynamic, and kinetic data; 3. Study the impact of the transmission process.