Product use : Mold test box is suitable for scientific research departments of universities and colleges, medicine, electronics, chemical industry and biology for the storage of bacteria and biological culture, which is the necessary equipment in scientific research laboratory. The antibacterial and aging ability of the product was tested by cultivation of fungi under certain temperature and humidity conditions. Box structure: Mold test box is made of 304 stainless steel plate, the shell of the box is treated by high quality A 3 steel plate, the shape is beautiful and novel. The interior is an integral frame structure to ensure that the box body does not deform in the course of transportation movement. The cooling and hot air circulation system consists of a heat-resistant stirred fan, heater, evaporator, special air duct, and uniform temperature in the studio. The large observation window lamp keeps the box bright, and uses the heat inlay tempered glass to observe the condition of the box clearly at any time. The water tank is placed in the lower right part of the control box and has automatic protection for water shortage, which is more convenient for the operator to replenish the water source. Refrigeration system: The refrigerator uses the original French "Taikang" fully enclosed compressor. The unit dehumidification system is used in the refrigeration system. The multi-wing fan is used for strong air supply circulation to avoid any dead angle and the distribution of temperature and humidity in the test area is uniform. The design of return air, wind pressure and wind speed are in accordance with the test standard, and can make the instantaneous temperature and humidity stabilization time fast. Heating, cooling, humidifying system completely independent can improve efficiency, reduce test costs, increase life, reduce failure rate. Criteria met: GB/T10588-2002 Model specification and technical parameters: Model: MSX-800 Studio size D*W*H(mm):800*1000*1000 Shape dimensions D*W*H(mm):1500*1540*2150 Performance indicators: Temperature range: 20 ℃ / 80 ℃ Humidity range: 45 / 98 RH Fluctuation / uniformity: ±0.5 ℃ / ±2 ℃ Humidity deviation: + 2 + 3 RH Heating rate: 20 ℃ to 80 ℃ ≤ 30min Cooling rate: 80 ℃ to 20 ℃ ≤ 30min Temperature operation system: Controller: imported LED digital display Pi D S S R microcomputer integrated controller Precision range: temperature 0.1 ℃, indicating precision: temperature 0.1 ℃ Temperature and humidity sensor: platinum resistor PT100 Ω / MV Heating system: Ni-Cr alloy heater Humidification system: shallow trough humidification Dehumidification system: a laminar contact dehumidification system using dew point temperature of evaporator coils Water supply system: automatic control of humidified water supply Refrigeration system: fully enclosed air-cooled single-stage compression refrigeration / original French "Taikang" / fully closed air-cooled laminated compression refrigeration Safety protection: leakage, short circuit, overtemperature, water shortage, motor overheating, compressor overvoltage, overload, overcurrent protection Power supply voltage: AC380V ±10% 50 ±0.5Hz three-phase five-wire system Using environment: 5 ℃ + 30 ℃ ≤ 85%RH
Product use : Mold test box is suitable for scientific research departments of universities and colleges, medicine, electronics, chemical industry and biology for the storage of bacteria and biological culture, which is the necessary equipment in scientific research laboratory. The antibacterial and aging ability of the product was tested by cultivation of fungi under certain temperature and humidity conditions.
