| Measuring project | |
| Measuring project | Point, line, circle, part of the circle, oval, circular arc processing (arc radius and center distance, the center of the circle to the straight line distance, the distance of the intersection point to the center of the circle, etc.), high and low Angle, distance, processing Angle, the Angle of the straight line (coordinates), straightness, groove depth and groove width, river bank, groove pitch, horizontal distance, crown (logarithmic curve), profile and other parameters |
| Measuring range | |
| X axis (horizontal guide rail) | 100mm |
| Z1 axis (sensor) | 40mm |
| Z axis (upright) | 400mm |
| certainty of measurement | |
| X axis (LX axis guide rail moving distance) | ±(1+L/300)μm |
| Z1 axis (H=Z1 axis height measurement) | ±(1+2H/100)μm |
| X-axis horizontal arm | |
| straightness | 0.8μm/100mm |
| Grating resolution | 0.05μm |
| Raster origin | enter port |
| Z1 axis sensor | |
| Resolution ratio | 0.02μm |
| Sensor type | grating sensor |
| Place of production | enter port |
| Moving direction | Front / rear direction |
| Dynamometry | 0.5-6g |
| Needle tip | Cemented carbide: 0.05mm / 0.01mm |
| Climbing angle | Up 77 degrees, down 88 degrees. |
| Speed | |
| Measuring speed | 0.1mm/s,0.2mm/s,0.5mm/s（User-defined） |
| Positioning speed | 0.1mm/s,0.2mm/s,0.5mm/s（User-defined） |
| Graphic magnification / reduction | |
| Graphic amplification | Scalable, magnified |
| Integrated adjustment table | |
| Integrated adjustment table | X axis horizontal tilt adjustment range: ±30 ° Y-axis adjustment range: ±7.5mm Z axis rotary adjustable 360 degrees (with fine tuning device) |
| Installation requirements | |
| Source | 220-240V AC, 50HZ, single ground wire; maximum power consumption 450W |
| Compressed air | Pure compressed air: 0.4MPp, consumed 0.1m3 / min (0.25m3 / min supplied by gas source) |
| Environmental Requirements | Working temperature: 10 °-30 °(normal temperature); humidity 20-80%RH (no dew), good ground line, no obvious vibration source |
Please inquire
Please inquire
