Introduction: This rheometer is a computer-controlled intelligent constant-pressure capillary rheometer. The extrusion speed of capillary tubes of various specifications under various pressures under different heating rates and different temperatures is measured by the computer. Due to the particularity of the sample, this machine is specially heated in a water bath, and an explosion-proof design is added, and the man-machine operation is separated to increase the safety of the test personnel. This machine is controlled by a computer, records the extrusion speed, pressure and heating temperature, automatically processes it into a viscosity number, draws a curve, and prints a complete report. Technical Parameters: 1. Temperature range: room temperature~90℃±1℃ 2. Heating rate: 0.5 ~ 6℃/min, continuously adjustable, and rapid heating 3. Temperature measurement accuracy: computer display <±0.5℃, resolution: 0.1℃ 4. The diameter of the plug head: designed according to user requirements, the plug rod can be made of steel or copper, and the plug head should be covered with a layer of polyethylene plastic to prevent hard contact. 5. Total weight of sample: 15g 6. Specific gravity of sample: 1.34g/cm3 7. Plug head area: 1cm2 8. Pressure range: 1-50MPa±1% 9. Specification of discharge port (diameter×length): (mm×mm) ф1.5×5; ф1.5×10; ф1.5×20; ф1.5×40; ф2.0×5; ф2.0×10; ф2.0×20; ф2.0×40; ф3.0×5; ф3.0×10; ф3.0×20; ф3.0×40 10. Material of discharge port: Tungsten carbide 11. Rated load value of the sensor: 500kg 12. Load measurement accuracy: ±1% 13. Load resolution: 20000 yards 14. Computer speed setting: 100mm/min-0.001 mm/min 15. Displacement measurement accuracy: ±0.5% 16. Power supply: 220V, 50Hz, power <400W
Introduction: This rheometer is a computer-controlled intelligent constant-pressure capillary rheometer. The extrusion speed of capillary tubes of various specifications under various pressures under different heating rates and different temperatures is measured by the computer. Due to the particularity of the sample, this machine is specially heated in a water bath, and an explosion-proof design is added, and the man-machine operation is separated to increase the safety of the test personnel. This machine is controlled by a computer, records the extrusion speed, pressure and heating temperature, automatically processes it into a viscosity number, draws a curve, and prints a complete report.
