Introduction
MD-S900Z pressure controller is a high-precision intelligent controller integrating pressure measurement, display and control. Its main application is automatic control operation of various water treatment systems, electromechanical equipment automation, engineering machinery and medical equipment.
The MD-S900Z pressure controller realizes the unobtrusive operation of the device in the true sense, and the setup is simple. The main functions are:
Realize low pressure automatic start, high pressure automatic stop;
Delay start can be set to prevent frequent opening of the device;
Automatically stop after water, prevent dry pumping;
Overpressure automatically alarms and stops equipment operation;
Password protection can be entered to prevent non-professionals from modifying the set parameters. Features
1.100mm axial belt edge, stainless steel housing, stainless steel joint
2. Realize low pressure start High pressure stop (or high pressure start, low pressure stop) function
3. The upper and lower limits of the two pressure control points can be freely set and adjusted to meet different control requirements.
4. 4-digit LED real-time digital display pressure value, easy for users to observe.
5. Three pressure units are available for switching.
6. Built-in relay signal output, anti-backlash setting to avoid frequent movement of the controlled device.
7. The service life is longer than the traditional mechanical switch, and it will not be ineffective for long-term use.
8. Control accuracy is higher than traditional mechanical switches, no noise.
9. Shockproof, strong anti-interference, fast response and stable performance. Technical Parameters
Pressure range: 0-0.2...0.6...1.0...1.6...2.5...5...10...25...40...60...100...160Mpa
Micro pressure range: 0-5kPa...10...25...50...100kPa
Output form: Relay output, normally open normally closed
Output relay capacity: 220V AC 5A
Power supply: 220V AC; 24V DC; 380V AC
Setting range: The control point can be set for the full range segment and the anti-fluctuation hysteresis setting can be set.
Accuracy: 0.5% FS
Measuring medium : gas, water, oil
Operating temperature: -20 ~ 65 ° C
Interface size: G1/2 (four-way water pipe thread)
M20*1.5 (pressure gauge interface)
G1/4 (two-pipe thread)
Introduction
MD-S900Z pressure controller is a high-precision intelligent controller integrating pressure measurement, display and control. Its main application is automatic control operation of various water treatment systems, electromechanical equipment automation, engineering machinery and medical equipment.
The MD-S900Z pressure controller realizes the unobtrusive operation of the device in the true sense, and the setup is simple. The main functions are:
Realize low pressure automatic start, high pressure automatic stop;
Delay start can be set to prevent frequent opening of the device;
Automatically stop after water, prevent dry pumping;
Overpressure automatically alarms and stops equipment operation;
Password protection can be entered to prevent non-professionals from modifying the set parameters.
