MD-S800Z axial digital pressure controller Introduction
The MD-S800Z pressure controller is an axially mounted 75mm 304 housing digital pressure controller (with side 100mm), a high-precision intelligent controller integrating pressure measurement, display and control. The main application is various types of water. Processing system, electromechanical equipment automation, engineering machinery, medical equipment and other industries fully automatic control operation.
It can measure: water, air, hydraulic oil and other media that are non-corrosive to stainless steel.
The main functions realized are low pressure closing, high pressure opening (or low pressure opening, high pressure closing) function;
In the system function, you can set password protection, reverse control, leakage protection, time protection, delay action, etc. It is a true intelligent pressure controller. Features
75mm axial 304 stainless steel case (with side 100mm) 304 stainless steel joint
The upper and lower limits of the two pressure control points can be freely set and adjusted to meet different control requirements.
4-digit LED real-time digital display pressure value, easy for users to observe.
Three pressure units are available for switching.
Built-in relay signal output, anti-backlash setting to avoid frequent movement of the controlled device.
The service life is longer than the traditional mechanical switch, and it will not be ineffective for long-term use.
Control accuracy is higher than traditional mechanical switches, no noise.
Shockproof, strong anti-interference, fast response and stable performance. Technical Parameters
Pressure range
Negative pressure: 0~-100kPa (0~-0.1MPa)
General: 0-0.2...0.6...1.0...1.6...2.5...5...10...25...40...60...100...160Mpa
Micro pressure: 0-5kPa...10...25...50...100kPa
Output form: Relay output, normally open normally closed
Output relay capacity: 220V AC 5A
Power supply: 220V AC; 24V DC; 380V AC optional
Setting range: The control point can be set for the full range segment and the anti-fluctuation hysteresis setting can be set.
Accuracy: 0.5% FS
Measuring medium: gas, water, oil
Operating temperature: -20 ~ 65 ° C
Interface size: G1/2 (quadruple thread)
M20*1.5 (pressure gauge interface)
G1/4 (two-pipe thread)
