LC - TS6 molten iron composition analyzer Brief introduction:
LC - TS6 type furnace hot metal component tester testing time is about 2 minutes before, in hot metal can be finished waiting time detection, then according to automatically calculate the carburant, ferrosilicon, scrap supply adjustment of molten iron composition, proper molten iron ingredients after casting. Features:
1. Complete industrial environment design, vertical structure, stable and reliable performance, easy operation.
2. Target material selected (FC, FCD) : can be set up to 10 commonly used materials.
3. Before furnace used for rapid determination of cast iron original CE % and carbon content of molten iron carbon equivalent C % % Si, Si content, tensile strength (FC) speculated that value.
4. Wide measuring range: C % : 2.8% - 2.8%, Si % : 0.9% - 0.9%, CE % : 3.2% 4.83%.
5. High accuracy, good stability. % % accuracy within 0.05% of C, Si precision is within 0.1%.
6. Measuring speed, measuring time not more than 3 minutes, is advantageous for the furnace before composition adjustment.
7. Carbon, silicon value compensation correction: according to chemical analysis or spectrum analyzer can adjust compensation silicon carbon value.
8. The cooling curve and measurement data CE, % % C, Si, TL, TE at the same time, according to a clear and straightforward.
9. The measured values are out of the target within the upper and lower, there will be up and down arrow to remind.
10. According to the component content of determination, has been set and the goal of the iron water composition and insufficient material retained rate automatic calculation amount.
11. Can be set at the same time, the checking-measuring curve to adapt to the different types of applications. Technical parameters
1. The carbon content of C % detection: measuring range of 2.8 ~ 4.2%, measurement accuracy of 0.05 mm or less
2. The silicon content of SI % detection: measuring range of 0.9 ~ 3.0%, and measuring accuracy of 0.1 mm or less
3. The carbon equivalent of CE % detection: measuring range of 3.2 ~ 4.8%, measurement accuracy of 0.1 mm or less
Brief introduction:
LC - TS6 type furnace hot metal component tester testing time is about 2 minutes before, in hot metal can be finished waiting time detection, then according to automatically calculate the carburant, ferrosilicon, scrap supply adjustment of molten iron composition, proper molten iron ingredients after casting.
