Introduction: The ATP fluorescence rapid detector can be used in special equipment for rapid determination of the cleanliness of the surface of medical system objects and the hands of operators. It can also be used for surface cleanliness determination and microbial growth control. The device uses chemical reactions to detect ATP, and samples are collected with ATP swabs. The ATP swab is soaked in buffer, which helps to extract biological material (ATP) from dry or wet surfaces. The swab also contains an agent that can break through the biofilm, exposing the organisms that may be under it. After the specimen is collected, the swab should be soaked in a solvent that can release ATP from the cells. Then the ATP released from the cell and the ATP wiped from the surface of the device by the swab react with Ultrasnap's unique liquid reagent. characteristic: High sensitivity; 10-15～10-18 mol Fast speed; conventional culture method is more than 18-24h, while ATP only needs ten seconds. Feasibility: There is a clear correlation between the number of microorganisms and the ATP contained in the microorganisms. By detecting the content of ATP, the number of microorganisms in the reaction can be obtained indirectly Operability; the traditional culture method needs to be operated by trained technicians in the laboratory; and the ATP rapid cleanliness detection operation is very simple, and only simple training can be performed by general staff on site. The main parameters: 1. Large-screen clear LCD display 2. Detection accuracy: 5×10-18mol 3. Coliform group: 1-106cfu 4. Detection range: 0 to 9999 RLUs 5. Detection time: 15 seconds 6. Detection interference: ±5﹪ or ±5 RLUs 6. Operating temperature range: 5℃ to 40℃ 7. Operating humidity range: 20—85﹪ 8. ATP recovery rate: 90-110% 9. Detection mode: RLU, coliform screening 10. 50 user ID settings 11. The number of result limits that can be set: 251 12.1999 memory storage 13, automatically judge qualified 14. Automatic statistics of pass rate 15. Built-in self-calibration light source 16. Self-check after booting in 30 seconds 17. Equipped with RS232 interface, the results can be uploaded to PC 18. Instrument size (W×H×D): 192mm×87mm×34mm 19. Use two standard AA batteries or rechargeable lithium batteries 21. Standby state (20℃): 6 months 22. Chinese operation manual 23. Stable liquid luciferase 24. Wetted integrated collection swab Random configuration: ATP fluorescence detector (handheld) host, instrument bag, lanyard, battery, PC data cable, data analysis software, Chinese operation manual
Introduction: The ATP fluorescence rapid detector can be used in special equipment for rapid determination of the cleanliness of the surface of medical system objects and the hands of operators. It can also be used for surface cleanliness determination and microbial growth control. The device uses chemical reactions to detect ATP, and samples are collected with ATP swabs. The ATP swab is soaked in buffer, which helps to extract biological material (ATP) from dry or wet surfaces. The swab also contains an agent that can break through the biofilm, exposing the organisms that may be under it. After the specimen is collected, the swab should be soaked in a solvent that can release ATP from the cells. Then the ATP released from the cell and the ATP wiped from the surface of the device by the swab react with Ultrasnap's unique liquid reagent.
