GDS-80P quartz crystal oscillator tester Introduction: Crystal impedance meter (crystal oscillator tester) is a professional crystal oscillator testing equipment that mainly tests the corresponding electrical parameters of passive crystal oscillators. The π - network zero phase method is used to measure the series resonant frequency, and the direct impedance method is used to test the load resonant frequency and load capacitance. It has high measurement accuracy and fast speed. It has the function of measuring parameters such as series resonant frequency Fs, load resonant frequency FL, series resonant resistance Rs, load resonant resistance RL, load capacitance CL, dynamic capacitance C1, dynamic inductance L1, quality factor Q, electrostatic capacitance C0, frequency traction force Ts, etc. The load capacitance can be freely programmed and set within the range of 1-100P to meet the requirements of crystal oscillator testing for different load capacitors, The intelligent network analysis technology overcomes the shortcomings of using physical capacitance method to test electrical parameters in crystal oscillator testing equipment on the market, eliminates the trouble of manual calibration, and makes crystal oscillator testing easier. Technical parameters: 1. Center frequency range: 10KHz-200KHz, 1MHz-200MHz can be set arbitrarily 2. Scanning range: ± 1000ppm (default ± 400ppm) 3. Load capacitance: 1-100P can be set arbitrarily 4. Measurement range of series resonant frequency Fs: ± 1000ppm (default ± 400ppm) Measurement accuracy: ± 5ppm 5. Series resonant resistance Fr: 1MHz-100MHz: 1 Ω -1000 Ω (2 ± 10% * R Ω) 10KHz-200KHz: 10K-300K (2 ± 10% * R K Ω) 6. Measurement range of load capacitance CL: 1-200PF 7. Time base error: ± 1ppm 8. Measurement accuracy of load resonance frequency FL: ± 5ppm+time base error+0.5Pf * frequency traction force Ts
Introduction: Crystal impedance meter (crystal oscillator tester) is a professional crystal oscillator testing equipment that mainly tests the corresponding electrical parameters of passive crystal oscillators. The π - network zero phase method is used to measure the series resonant frequency, and the direct impedance method is used to test the load resonant frequency and load capacitance. It has high measurement accuracy and fast speed. It has the function of measuring parameters such as series resonant frequency Fs, load resonant frequency FL, series resonant resistance Rs, load resonant resistance RL, load capacitance CL, dynamic capacitance C1, dynamic inductance L1, quality factor Q, electrostatic capacitance C0, frequency traction force Ts, etc. The load capacitance can be freely programmed and set within the range of 1-100P to meet the requirements of crystal oscillator testing for different load capacitors, The intelligent network analysis technology overcomes the shortcomings of using physical capacitance method to test electrical parameters in crystal oscillator testing equipment on the market, eliminates the trouble of manual calibration, and makes crystal oscillator testing easier.
