GDS-5TX Clock Tester Introduction: The GDS-5TX broadband clock tester is default suitable for precise measurement of electronic product clock circuits using 4M, 4.194304M, 12M, 14.31818M, 32768Hz, and 1Hz, such as automotive electronic clocks, smart meters, computer motherboards, temperature controllers, timers, electronic scales, and timing functions on electronic cash registers. Its appearance is shown in Figure 1. Among them, there are four frequency points at the MHz level, and other frequency points between 1-100M can be customized according to the user. The GDS-5TX broadband clock tester is equipped with an RS232 interface that can be connected to a PC to send real-time measurement data to the upper computer for correcting circuit clock errors. Additionally, a 1.0 meter probe should be configured to accommodate larger circuit board measurements. Features: 1. Sensors with ultra sensitivity make reception more sensitive; 2. The measurement clock adopts non-contact method, and the second pulse is connected to the electrical appliance through contact method 3. The use of brushed oxidation panels is aesthetically pleasing and elegant; 4. Built in fast processor and TCXO (reference clock crystal oscillator with temperature compensation); 5. Use a 16 level level indicator to visually and clearly indicate the strength of the measured signal; 6. The upper and lower limit values can be set, and if they exceed the range, an automatic alarm will be triggered; 7. The human-machine dialogue adopts a rotary encoder encoding, which is easy to operate; 8. The accuracy is better than 0.2ppm. Technical parameters: Measurement range: multi rate electronic energy meters, electronic product clock circuits Power supply voltage: 220V AC 50HZ Measurement frequency: 4M, 4.194304M, 12M, 14.31818M, 32768Hz, 1Hz (32.768KHz-100MHz frequency points can be customized) 7 optional measurement cycles: 1 second, 2 seconds, 5 seconds, 10 seconds, 20 seconds, 32 seconds, 60 seconds Reference frequency: 16.384MHZ TCXO Measurement accuracy: better than 0.2ppm Range: Five options available, PPm (one millionth error rate), s/d (daily error), s/m (monthly error), s/y annual error, F clock frequency error Signal strength indication: Level 16 indication is intuitive and clear to use Alarm setting range: positive and negative 200ppm Volume: 130 x 270 x 290 (mm) Display method: Four position 4.5-inch LCD display
Introduction: The GDS-5TX broadband clock tester is default suitable for precise measurement of electronic product clock circuits using 4M, 4.194304M, 12M, 14.31818M, 32768Hz, and 1Hz, such as automotive electronic clocks, smart meters, computer motherboards, temperature controllers, timers, electronic scales, and timing functions on electronic cash registers. Its appearance is shown in Figure 1. Among them, there are four frequency points at the MHz level, and other frequency points between 1-100M can be customized according to the user. The GDS-5TX broadband clock tester is equipped with an RS232 interface that can be connected to a PC to send real-time measurement data to the upper computer for correcting circuit clock errors. Additionally, a 1.0 meter probe should be configured to accommodate larger circuit board measurements.
