GDS-5C Clock Tester Introduction: The GDS-5C clock tester is suitable for precise measurement of 32768Hz crystal oscillator clock circuits such as electronic timers, electronic temperature controllers, telephones, electronic scales, and remote controls. It has three ranges: ppm (one millionth difference), s/d (daily error), and s/m (monthly error). Adopting a non-contact method without the need for electrical connection with the tested circuit, the luxurious aluminum alloy shell with a super large area sensor makes reception more sensitive. It is equipped with a built-in fast processor and TCXO accuracy better than 0.3ppm. The strength of the tested signal is indicated by a 16 level level display, which is intuitive and clear. The upper and lower limit values can be set, and if exceeded, an automatic alarm will be triggered. The set data can be retained for a long time without loss. Technical parameters: Measurement range: Suitable for clock circuits using 32.768kHz crystal oscillators, such as electronic timers, electronic temperature controllers, electronic scales, remote controls, etc. Power supply voltage: 220V AC 50HZ Reference frequency: 16.384MHz TCXO Precision better than 0.2ppm Range: 3 levels optional, PPm (one millionth error rate), s/d (daily error), s/m (monthly error) Signal strength indication: 16 levels for intuitive use Power switch mode: direct switch Alarm setting range: positive and negative 220ppm Sensor: Flat panel type Volume: 250 x 300 x 100 (mm) Weight: 3.5kg Shell: Luxury aluminum alloy shell Display method: Four digit display Processor: AVR fast type
Introduction: The GDS-5C clock tester is suitable for precise measurement of 32768Hz crystal oscillator clock circuits such as electronic timers, electronic temperature controllers, telephones, electronic scales, and remote controls. It has three ranges: ppm (one millionth difference), s/d (daily error), and s/m (monthly error). Adopting a non-contact method without the need for electrical connection with the tested circuit, the luxurious aluminum alloy shell with a super large area sensor makes reception more sensitive. It is equipped with a built-in fast processor and TCXO accuracy better than 0.3ppm. The strength of the tested signal is indicated by a 16 level level display, which is intuitive and clear. The upper and lower limit values can be set, and if exceeded, an automatic alarm will be triggered. The set data can be retained for a long time without loss.
