Introduction: The FTV-H manual furnace flame monitoring device is an industrial monitoring device that partially inserts a mirror tube from the furnace wall into the furnace to monitor the combustion status of the entire furnace. Its motion mechanism adopts a manual forward and backward motion, which can adjust the entire optical imaging mechanism to a 10 ° up and down swing angle, so that the image center during ignition and operation is aligned with the center of the monitor, achieving the best observation effect. This type of monitoring device has the advantages of simple structure, easy maintenance, and high cost-effectiveness. Technical parameters: Observation field range: 50 °, 90 °, 105 °, 120 °; Lens angle: 0 ° (direct view), 45 °, 60 °; Protective cover working environment: -40 ℃~70 ℃; Lens heat-resistant temperature: ≤ 2000 ℃; Required air source parameters for the device: Wind source pressure ≥ 0.3Mpa; Wind source flow rate ≥ 0.3m3/min; Wind temperature ≤ 40 ℃, dust particle size ≤ 10 μ M; Oil content ≤ 10mg/m3; Forward and backward mode: manual sliding; Installation method: welding; Working power supply: AC 220V, 50Hz, 50W; Overall weight: 36.5kg (on-site probe section).
Introduction: The FTV-H manual furnace flame monitoring device is an industrial monitoring device that partially inserts a mirror tube from the furnace wall into the furnace to monitor the combustion status of the entire furnace. Its motion mechanism adopts a manual forward and backward motion, which can adjust the entire optical imaging mechanism to a 10 ° up and down swing angle, so that the image center during ignition and operation is aligned with the center of the monitor, achieving the best observation effect. This type of monitoring device has the advantages of simple structure, easy maintenance, and high cost-effectiveness.
