Introduction: This product meets the new domestic standards API RP60, Q/SY 124-2007 and SY/T 5108-2006 fracturing proppant performance indicators and recommended testing methods, and QSY 125-2007 fracturing proppant performance tables and evaluation test methods The mass density of ceramsite per unit bulk volume of Ke fracturing proppant bulk density tester FT-109A is called the bulk density of ceramsite, which is the average density of three parts including the ceramsite itself, open pores and closed pores. testing method: 1. Ensure that the proppant sample is fully mixed, and is reduced into a representative sample of about 200g by the dividing device. Pour the proppant into the funnel in the BD tripod, pull apart the rubber ball, and after the proppant sample fills the barrel container, use a ruler to level the top of the container once. Ruike fracturing proppant bulk density tester FT-109A 2. Weigh the mass W of the proppant sample in the container with a balance. To 0.001g. Ruike fracturing proppant bulk density tester FT-109A 3. Calculate the proppant bulk density: BD (g/cc) = mass/100 Ruike fracturing proppant bulk density tester FT-109A Technical Parameters: The total height of the instrument table from the top of the funnel to the bottom of the barrel-shaped container: 304.8mm; The distance from the drop point of the proppant to an instrument table: 215.9mm; Funnel height: 76.2mm; The height of the funnel mouth is 12.7mm; Barrel container height: 76.2mm; The width of the instrument table: 30.48mm. Rubber blocking ball diameter: 30.48mm; Diameter of stainless steel bracket: 4.8mm; Barrel volume diameter: 38.1mm; The outer diameter of the top of the funnel: 139.7mm; The inner diameter of the top of the funnel: 114.3mm; The funnel and measuring cup are made of stainless steel. Configuration: brush; steel ruler; level; manual; certificate; warranty card;
Introduction: This product meets the new domestic standards API RP60, Q/SY 124-2007 and SY/T 5108-2006 fracturing proppant performance indicators and recommended testing methods, and QSY 125-2007 fracturing proppant performance tables and evaluation test methods The mass density of ceramsite per unit bulk volume of Ke fracturing proppant bulk density tester FT-109A is called the bulk density of ceramsite, which is the average density of three parts including the ceramsite itself, open pores and closed pores.
