Introduction:
FK-A tissue crusher is suitable for scientific research, medical treatment, chemical products, food processing, chopping and biochemistry, plants, nutrients and other experiments. Technical Parameters:
Power supply voltage: AC 220V 50 Hz
Motor power: 12Ow
Speed control: start - 12000 rpm
Timing: 5-60 minutes
Capacity range: 50-50Oml, zui up to 100Oml Instructions:
1. First lift the coupling connecting the motor and the chopping rod so that it can remove the chopped rod, take out the chopped cup, add the required chopped material and solution to the chopping cup, and install it as it is. Place the cup and the rod (the lower end of the rod is aligned with the shaft) and close the lid.
2. Look at the timer knob and turn it in the ON (normally open) position or the time position you want to specify.
3. Turn the speed control knob counterclockwise to the bottom position of the zui, turn on the power, turn on the power switch, the indicator light is on, then turn the speed control knob clockwise to the speed you need for homogenization, medium and low speed. can. When plant mashing, high speed should be used, and there is noise when crushing at high speed.
4. When replacing the solution, repeat the above operation after turning off the power. Precautions:
1. This machine adopts three-eye safety socket, and must be connected to the ground before use.
2. When working, place the machine on a flat and fastened table to prevent vibration. When crushing at high speed, use the hand to hold the lid.
3. When the coupling is difficult to slide up and down, one or two drops of oil should be injected to lubricate it.
4, it is forbidden to smash bones, mineral sand and other harder substances.
Introduction:
FK-A tissue crusher is suitable for scientific research, medical treatment, chemical products, food processing, chopping and biochemistry, plants, nutrients and other experiments.
