FE-30SST silicon steel sheet iron loss measuring instrument Introduction
FE-30SST LOSSMETER adopts small magnetic permeability meter design (30SST) and reference international common magnetic conductivity meter test standard, through the trace value of the trace source of the opposite circle, determines the effective magnetic circuit length, and performs complete air flux compensation to meet Direct measurement of single-piece samples is very convenient and accurate.
FE-30SST LOSSMETER is quite different from similar products on the market. The single machine is equipped with a calibrated magnetic permeability meter to meet the orientation and non-oriented single-chip silicon steel measurement, which can accurately measure the mass ratio of the silicon steel sheet to the total loss Ps and magnetic. Feeling Bm. It can be equipped with PC software, which can measure BH hysteresis loop, uH permeability curve and Ps-B loss curve. Under certain circumstances, it can meet the full performance parameters of the standard test silicon steel strip sample. Small silicon steel sheets use a small source of samples from companies or universities, but require small test equipment that is convenient and economical for sample inspection. Features
1.The panel is directly operated, and the stand-alone test can be completed in a single machine.
2.Loss comparison measurement of open magnetometer for single stator piece P1.5/50
3.Closed circuit measurement can lock the magnetic induction Bm test ratio total loss
4.Closed circuit measurement can lock the excitation magnetic strength Hm test magnetic sense
5.Closed-circuit magnetometer truly compensates for zero flux
6.Accurate measurement of oriented, non-oriented silicon steel by closed-circuit magnetic conductivity meter
7.Connect the computer to complete the test of various curves Technical Parameters
Power input: 220V ±20V/0.5A, 50HZ
Output power: 15V/1.5A
Test frequency: 50Hz, 60Hz free choice
Test mode: Lock B measurement H value and lock H measurement B value two modes
Bm setting range: 500mT~1900mT
Hm setting range: 100A/m~10000A/m
Accuracy: PS accuracy 2.0%, Bm accuracy 1.0%
Volume: 280mm*90mm*300mm
Sample requirements: Length: greater than 100mm, width: 20mm ~ 30mm
Sample requirements: Thickness: 0.1mm to 0.65mm
Sample Requirements: The sample is required to be leveled. Strictly speaking, the sample needs to be annealed to trace the national standard.
Introduction
FE-30SST LOSSMETER adopts small magnetic permeability meter design (30SST) and reference international common magnetic conductivity meter test standard, through the trace value of the trace source of the opposite circle, determines the effective magnetic circuit length, and performs complete air flux compensation to meet Direct measurement of single-piece samples is very convenient and accurate.
FE-30SST LOSSMETER is quite different from similar products on the market. The single machine is equipped with a calibrated magnetic permeability meter to meet the orientation and non-oriented single-chip silicon steel measurement, which can accurately measure the mass ratio of the silicon steel sheet to the total loss Ps and magnetic. Feeling Bm. It can be equipped with PC software, which can measure BH hysteresis loop, uH permeability curve and Ps-B loss curve. Under certain circumstances, it can meet the full performance parameters of the standard test silicon steel strip sample. Small silicon steel sheets use a small source of samples from companies or universities, but require small test equipment that is convenient and economical for sample inspection.
