C030 PTFE plate/sheet operation electrolytic cell Introduction: The electrolytic cell is made of polytetrafluoroethylene, which can be used for the electrochemical experiment of samples before electron microscope scanning, or for corrosion Used for coating corrosion performance test during corrosion test Technical features: 1. The electrolytic cell is divided into two layers, the upper layer is the cell body, and the lower layer is the fixed base plate 2. The electrolytic cell compresses the working electrode sample by tightening the screws around 3. The working electrode sheet of the electrolytic cell is a sheet working electrode, which is easy to install, disassemble and handle. 4. The electrolytic cell can be used for the electrochemical experiment before the sample is scanned by the electron microscope, or for the corrosion performance test of the coating during the corrosion test 5. The bottom of the electrolytic cell has a circular hole with a fixed area of 1 square centimeter (the required size can be customized according to requirements), and a ring that can be sealed. After placing the sample at the circular hole, adjust and tighten the screw on the top of the cell to make it compact the working sample piece to achieve the sealing effect 6. The conductive link of the working electrode of the electrolytic cell uses the principle of adhesion of copper tape and the working sample to conduct sample conductivity, 7. The copper tape is easy to use, easy to replace after corrosion, and can better ensure the conductivity. 8. The use effect of the electrolytic cell and electrode rack is better
Introduction: The electrolytic cell is made of polytetrafluoroethylene, which can be used for the electrochemical experiment of samples before electron microscope scanning, or for corrosion Used for coating corrosion performance test during corrosion test
