AE001 pneumatic liposome extruder Introduction:
The AE001 pneumatic liposome extruder is driven by nitrogen gas and generates single-layer liposomes and nucleic acid carriers by squeezing multi-layer liposome suspensions. Multi layer samples were forced to repeatedly pass through polycarbonate filters with predetermined pore sizes, forming uniform and smaller liposomes with particle sizes of 50-1000nm. Features:
1. All component materials, including O-rings, washers, etc., have passed FDA certification
2. It can be used in single or double sets
3. All contact material pipelines are made of 316L stainless steel material
4. It can be used for high concentration sample processing, and is equipped with temperature control devices before and after extrusion, which can effectively control the sample temperature
5. Pre set pressure protection valve, with a pressure of up to 1000Psi
6. All contact membrane surfaces are treated with electrolytic polishing, achieving a polishing degree of 1.5Ra (all far exceeding the polishing degree requirements)
7. Can be used in clean rooms and meets GMP standards
8. Can be used for the treatment of high concentration samples Technical parameters:
Model: AE001
Pressure: 0-1000PSI
Processing capacity: 2-10ml
Working temperature: 5-80 ° C
Filter membrane diameter specification: 25mm
Product particle size: 50-1000nm
Introduction:
The AE001 pneumatic liposome extruder is driven by nitrogen gas and generates single-layer liposomes and nucleic acid carriers by squeezing multi-layer liposome suspensions. Multi layer samples were forced to repeatedly pass through polycarbonate filters with predetermined pore sizes, forming uniform and smaller liposomes with particle sizes of 50-1000nm.
